How do you reset the service indicator on a Audi A3?

How do you reset the service indicator on a Audi A3?

Audi A3: How to Reset Service Reminder Light

  1. Step 1 – Press “Trip Reset” button and start engine. Pull the knob located on the right-hand side of the instrument cluster (trip reset button).
  2. Step 2 – Turn engine off.
  3. Step 3 – Repeat the procedure.

How do you reset the spanner light on an Audi A3?

To reset the Audi A3 spanner, change the ignition switch to the ON spot. There are two buttons in the instrument cluster, take out the RIGHT button once and release it to activate the reset mode.

How do you reset the service light?

Turn the ignition back to the ON position while holding the reset button. Watch the oil change or maintenance light carefully. It should start to blink. Allow the light to blink ON and OFF for a few seconds, then release the reset button and turn the ignition OFF.

How do you reset the check engine light on a 2008 Audi A4?

Audi A4 B8: How to Reset Check Engine Light

  1. Step 1 – Locate your battery.
  2. Step 2 – Remove negative terminal.
  3. Step 3 – Refit negative terminal and start car.

How do you reset the service light on a 2008 Audi A6?

2008-2015

  1. Start the engine.
  2. Press the CAR button to get to the service menu.
  3. From there use the bottom left button on the MMI Controller to CAR SYSTEMS.
  4. Scroll to and select SERVICE & CHECKS from the CAR SYSTEMS menu.
  5. Select SERVICE INTERVALS.
  6. Select RESET OIL CHANGE INTERVAL and confirm.

How do I reset dashboard after oil change?

Insert the key into the ignition and turn it to the “on” position without starting the engine. Depress the gas pedal slowly three successive times within 10 seconds. At this point, the system should have reset. You can verify by turning the ignition off and then on again.

Why is my maintenance required light still on after oil change?

Most often this just means your vehicle might be due for an oil change. The light will come on and remain on if the distance driven exceeds 5,000 miles after the maintenance data has been reset.

How do you reset service on an Audi A3?

Pull the RESET BUTTON until the SERVICE EXCEEDED BY appear. While the SERVICE EXCEEDED BY is displayed. PULL and HOLD the Reset Button for 5-10 seconds until ( —) message appear. Turn the IGNITION, RESET is complete. If this tutorial is not applicable to your vehicle.

Where is the service light on an Audi A3?

Turn engine off and then restart your engine to check the service light is no longer on display on the dashboard of your A3. Figure 2. Switch off the engine in your Audi A3. If the service light still appears on the dashboard of your A3, then you will need to repeat the above instructions.

How do you reset the oil service light?

And, SERVICE OEL or OIL, for the Oil Service interval. The oil service light reset procedure is as follows. Start with the ignition turned OFF Press and hold the button on the right side of the display. While turning the ignition on (position 2) Service OEL / OIL, should be displayed.