How do you unlock a fuel pump?

How do you unlock a fuel pump?

In order to unlock the fuel injection pump, loosen locking screw (4) on the fuel injection pump. Slide spacer (5) into position (ZZ). Tighten the locking screw against the spacer to a torque of 9 N·m (80 lb in). This will prevent the locking screw from tightening against the shaft of the fuel injection pump.

Where is the fuel pump located on a 01 Chevy Tahoe?

how do you change the fuel pump on a 2001 chevy tahoe? Hello, the fuel pump is located inside the fuel tank and the tank will need to be removed to replace the pump. Instructions below thanks.

Is replacing a fuel pump hard?

Replacing your fuel pump isn’t as hard as you might imagine. In most, you must drop the fuel tank, and first drain most gas if needed. Some vehicles have an access panel in the body to get to the top of the tank to remove the assembly without dropping the tank.

How much is a fuel pump for a 2007 Tahoe?

2007 Chevrolet Tahoe Fuel Pump – from $149.99+ | AutoZone.com.

Where is the fuel pump on a 1999 Chevy Tahoe?

Sliding under the car and follow the fuel lines toward the fuel tank. Once the pump is located, unbolt it and then let it drop slowly. B. If your pump is inside the fuel tank, it is usually under the carpet or beneath the back seat….

Where is the fuel pump in a Chevy Tahoe?

First step was to locate where the fuel pump was under the rear floor pan. This picture is looking into the rear drivers’ side wheel well in front of the tire. The fuel lines helped to narrow it down. Once I found the fuel pump’s location the next step was to expose the rear floor pan under the back seat.

Where is the fuel pump on the floor?

The fuel pump is directly under the raised spot. This the where you will be cutting the access point. Now it is time to cut the access. There are 4 spot welds on the raised portion of the floor pan. I cut on the other side, side closest to the center line of the car, I suggest you cut on the side closest to the door.

Where are the spot welds on a Chevy Tahoe?

There are 4 spot welds on the raised portion of the floor pan. I cut on the other side, side closest to the center line of the car, I suggest you cut on the side closest to the door. This is where the black line is in the picture.