What kind of transmission fluid do I put in a Ford Ranger?

What kind of transmission fluid do I put in a Ford Ranger?

Mobil 1 Synthetic Transmission Fluid Dexron, Mercon 1 Quart.

What kind of fluid goes in a Ford transmission?

Dexron III/Mercon – This is one of the most common fluids on the market. Most GM and Ford units call for this type of ATF, as well as many imports. If your owners manual recommends any form of Dexron, or any Mercon – other than Mercon V – this is the fluid you want.

What kind of transmission fluid does a 2009 Ford Ranger take?

Mercon V Automatic Transmission
Ford Ranger 2009, Mercon V Automatic Transmission Fluid by Motorcraft®.

What kind of transmission fluid does a 2007 Ford Ranger take?

Ford Ranger 2007, Mercon V Automatic Transmission Fluid by Motorcraft®.

How do you put transmission fluid in a Ford Ranger?

Using a funnel, fill the transmission with 7 quarts of transmission fluid to start. Start the truck and let it run for 2 minutes and then, holding the brake, shift it through reverse and drive, hesitating for 30 seconds in each position. Put the transmission back into neutral.

What type of transmission fluid does a 92 Ford Ranger take?

Can I use transmission fluid in my transfer case?

Transfer cases may be filled with gear oil, automatic transmission fluid (ATF), or specialty lubricants. It is important to regularly inspect the transfer case for any damage, leaks, or other concerns.

Is it bad to mix transmission fluid brands?

Is it OK to mix synthetic ATF with a conventional and/or synthetic blend ATF? Yes. Synthetic ATF and conventional fluids are 100 percent compatible with each other.

Do Ford Rangers have transmission problems?

Some of the noted 2001 Ford Ranger problems are transmission failures, rough shifting, and the overdrive light going on and off. Many of the issues with the 2001 model have also been reported to occur even before the vehicle reached 100,000 miles. Additionally, the 2001 Ford Ranger has nine official recalls.

Does the Ford Ranger need a transmission cooler?

The Ford Ranger has an optional transmission cooler available for it. In general You should have a transmission cooler installed when You have an automatic transmission and You plan on towing with the vehicle.

Is Mercon ATF still available?

All automotive repair professionals are encouraged to make the necessary preparations with customers to ensure a seamless transition to the appropriate fluids once MERCON is discontinued.

What is a standard transmission fluid?

Manual transmission fluid can vary, however, using either plain motor oil , a transmission oil known as heavyweight hypoid gear oil , or automatic transmission fluid . The type of transmission fluid to use in vehicles with standard transmissions can usually be found in the maintenance section of the owner’s manual.

How many quarts of transmission fluid in a 1995 Ford Ranger?

The biggest engine available for the 1995 Ford Ranger is a 4.0-liter V-6 engine which uses 5W-30 motor oil and requires 5 quarts for oil changes. For manual transmission fills, this truck requires 5.5 pints; 9 to 10.1 quarts of fluid are required for the automatic transmission.

How to identify a Ford Ranger 5-speed transmission?

Step 1. Look under the transmission at the bottom pan (where the transmission screen is) and count the number of bolts attached to the pan. A 12-bolt

What is type a transmission fluid?

Transmission fluid is a type of hydraulic oil. It is highly flammable. A motor uses oil for lubrication, water for cooling, and a crank and pistons to transfer energy to the rest of the vehicle. Transmission fluid combines all three of these jobs into one fluid.