How do I reset my Radio Shack Pro 164 scanner?

How do I reset my Radio Shack Pro 164 scanner?

To initialize the scanner, turn the scanner off, turn it on again, when the welcome message comes on the display, press 0, then press 1, then ENT. “Initializing please stand by” appears for about 5 seconds. When the initialization is complete, the scanner will show Bank 0, Ch 00.

Is the radio shack PRO 164 a digital scanner?

The pro 164 is a analog scanner not digital so please check with your city to see if this can be use there before you buy.

How do I program my Pro 164 trunking scanner?

1. Press PROG, then press TRUNK.
2. Press FUNC, then use an UP or DOWN ARROW to select a bank.
3. Repeatedly press MODE to select a trunking mode (Motorola, EDACS,LTR).
4. Press PROG.
5. Enter the first control channel freq.
6. Repeatedly press MODE to select a trunking mode (Motorola, EDACS, LTR).

Is the Radio Shack Pro 163 a digital scanner?

5.0 out of 5 stars A great analog scanner with a wide frequency range. It is not digital.

How do I program my Radio Shack 1000 channel scanner?

Press the “Program” button, then “Limit.” “LO” will appear on the screen. Enter the low frequency where you want to begin searching. Press the “WX/E” button and “HI” will appear on the screen. Enter the highest frequency you want to search to and press “WX/E” again.

How do you program a Radio Shack Pro?

Turn the squelch knob located by the volume control both ways until the static stops. Add frequencies to your scanner. Press “Manual” and enter the channel where you want to store the frequency. Press “Program” and enter the frequency on the keypad.

How do I get my Radio Shack scanner to scan?

How do I reprogram my Radio Shack scanner?

How do I reset my Radio Shack scanner?

From the owner’s manual, Power on the scanner, and while the “Welcome” screen is showing, press the “zero” key followed by the “one” key.