Admin Table of Contents
What do spark plug wires attach to?
distributor cap
Note that in some vehicles, this end of the spark plug wire is permanently attached to the distributor cap. You know what that means – You’ll have to replace the entire distributor cap. Sorry ’bout your luck. Check your spark plugs to ensure they’re still in good condition.
Why is it important to attach the correct spark plug wire to the correct spark plug location?
Putting spark plug wires is an easy process, but you need to be very careful. If you place the spark plugs wrongly, then it will affect the performance of the engine. If your mistakes are more severe by interchanging more than two plugs, the engine will not start.
Are spark plug wires universal?
Spark plug wires are commonly direct-fit to work on a specific application. This makes installation very easy; however, you can also find universal spark plug wires that can be cut to fit.
Why should you vacuum around a spark plug before removing it?
A collection of spark plug wires — always pull from the boot, not the wire. Clean the area around the plug with compressed air or a wet/dry vacuum. This helps prevent anything from falling into the cylinder once you get started.
How to troubleshoot a 1997 Ford Ranger coil pack?
Connect the electrical connector to the ignition coil pack if the coil pack tests are completed. Open the hood on the Ranger and set the hood prop. Turn the multimeter dial to the Ohms setting. With the ignition off, disconnect the electrical connectors from the right and the left hand ignition coil packs.
Where do you put the spark plug wire in a car?
You can find it by checking the cylinder block numbering format from the repair manual. All the cylinders are numbered. They work differently as per your car’s model. So, connect a spark plug wire between the #1 cylinder and the distributor’s #1 terminal.
Where are the cylinders on a Ford Ranger?
If you are looking under the hood from the front grill, on your left side are cylinders 1, 2 and 3 in that order and on the right side you have 4, 5 and 6 in that order. Cylinders 3 and 6 are closest to the firewall, cylinders 1 and 4 are closest to the front of the truck where you are standing.
What happens if one ignition coil pack is faulty?
On the 2.3-liter four-cylinder engine, if one ignition coil pack is faulty, that does not mean that the second ignition coil pack is faulty as well. Tim Petruccio is a professional writer and automotive mechanic.