Table of Contents
What engines can you put in a Fiero?
V6-204 CID, 3.4L, Pushrod Engine The 3.4 Liter 60 degree pushrod engine is one of the most logical choices for replacing the old, worn out, 2.8 Fiero engine. This engine is available as a like-new, factory rebuild or factory crate engine.
Can you fit a V8 in a Pontiac Fiero?
Dropping a General Motors Small Block V8 into the rear of the Pontiac Fiero is a relatively easy and inexpensive way to transform the mid-engine sports car into a much more serious performance package. Unlike many used Fieros we see, this particular car’s interior has been very well maintained.
Who does Fiero engine swap?
From commuter to beast Many Fiero owners take advantage of the car’s large engine bay to host a variety of swaps, including the Buick 3800 Supercharged, Chevy LS motors, and even Cadillac Northstars. The 3.4 V-6 in Miller’s car, though, shares the same block as the original 2.8 and is a factory-perfect fit.
How much horsepower does a 87 Fiero have?
Although the base engine was GM’s Iron Duke 2.5-liter four-cylinder, the Fiero GT used a more powerful fuel-injected 2.8-liter V-6 rated at 140-horsepower – that might not seem like a lot, but this car was smaller and lighter than the 240-horsepower Corvette from 1987.
Why is the Fiero bad?
Poor reliability and performance, expensive maintenance, and an awfully heavy and underpowered engine did not help the case either. Motor One calls it the worst sports car. Anyways, the number of reported fires was so huge that the cars had to be recalled. One Fiero exploded out of every 508 cars sold.
Why was the Fiero discontinued?
Despite the innovations, the model was discontinued by General Motors after annual sales fell steadily. The safety reputation was bad because of explosive fires and multiple recalls. Worse, the car was a money loser—General Motors lost about $2000 for every Fiero it built.
How fast is a 1986 Pontiac Fiero?
The sluggish performance seemed to be solved by adding a 140 hp 2.8-liter push-rod V6 in 1985 and then a 5-speed manual gearbox for the V6 in 1986. Combining them improved 0-60 mph to 8-second range and raised top speed to 125 mph.
Can a V-8 engine be installed in a Fiero?
Our Fiero V-8 Engine Conversion Kits allow you to install a small block Chevy engine into any 1984 thru 1988 Pontiac Fiero. They allow you to retain all stock options, including a/c. This kit is designed to be a bolt on installation with no frame cutting required.
What are the engine parts for a Pontiac Fiero?
BLOCK #459. Call NuTech at 1-800-790-9094 for customer service, availability and technical assistance. Notes: Long block, IMPORTANT: See Warranty Information Bulletin. The VIN #is required to ensure that the correct part is shipped. Block Cast #91820, 72065, 369. Crank Cast #817. Left Head Cast #877, 884, 879. No Fuel Pump Hole.
Can a Fiero stick be used as an engine?
You can, however, bolt the Fiero stick transmission directly up to this engine. Special clutch and flywheel are required. This Engine is a high-performance upgrade. It is a significant upgrade over the stock Fiero Engine, probably one of the best upgrades to your Fiero. This engine block is aluminum, with cast heads.
Do you need a VIN number for a Pontiac Fiero?
The VIN# is required to ensure that the correct part is shipped. With cast iron head. Call Tri Star at 1-855-459-6671 for customer service, availability and technical assistance.